| Specification |
| Approvals/certifications | Certified to EN54-2 & 4 by the LPCB.
|
| Mains supply | 230V 50/60Hz.
|
| Mains rated current | 350mA maximum.
|
| Internal power supply | 19V-28.5V (27V nominal). Ripple 7V maximum (battery fault).
|
| Total output current limited to | 1.5A @ 230Vac (ImaxA eq 146mA).
|
Quiescent current
| 25mA (mains failed, internal sounder active, PSU & gen fault LED lit).
|
Max battery size and type
| 2 x 12V 3.2Ah VRLA connected in series. Min. battery size 1.2Ah.
|
No. of detector zone circuits
| The CFP704-2 has 4 AlarmSense zone circuits which are compatible with Apollo's AlarmSense range of detectors & call points AND sounders & visual indicators. (Max. length per circuit is 500m). |
Call point resistor value
| Only use AlarmSense call points.
|
Max. devices per detector zone
| 25 AlarmSense detectors/manual call points per AlarmSense zone. For AlarmSense sounder limitations per AlarmSense zone see 'Max. sounder output current' section. |
No. of conventional sounder circuits
| 4 - these are additional conventional (non-AlarmSense) sounder circuits; Max. length per circuit is 500m.
|
EOL resistor value
| 6800O 5% Tol. 0/25W (blue, grey, red, gold).
|
Alarm voltage
| 27V max, 20V min (final battery voltage).
|
Max. sounder output current
| Each AlarmSense zone circuit & each conventional sounder circuit will support a max. sounder current of 200mA. Distribute sounder loads as evenly as possible. Total sounder loading per panel should not exceed 1.25A.
|
Auxiliary relays
| Two: (1) Aux. Fire; (2) Fault. Volt free single pole changeover. Max. switch current 1A; Max. switch voltage 30Vdc.
|
Open collector outputs
| Two: (1) Reset (Active during reset cycle); (2) Remote (Active during any unsilenced fire condition provided all relevant delays have expired). Max. sink current 30mA, Max. open circuit voltage 27Vdc).
|
Other outputs
| 24V Aux. Power (Protected by a resettable fuse. 100mA min. hold current. Resets when fault removed).
|
Auxiliary inputs
| Two: (1) €˜Class Change€™ (constant sounders); (2) Alert (pulsed sounders). Connect to 0V to trigger, Max. input voltage 27V (non-latching).
|
Engineer (AL3) functions
| Program coincidence (double knock); Invoke One Man Walk Test; Program delays; Set up zones for non-latching operation; Program sounders to resound (or not resound) when a new zone enters alarm; Enter fault diagnostic facilities.
|
Expansion connections
| Yes - for optional network driver cards (one required per repeater system), relay output cards and EN54-13 sounder circuit interface boards.
|
Product dimensions (mm)
| 380 W x 235 H x D 96mm.
|
Construction & finish
| Plastic lid and base; RAL7035 textured.
|
IP Rating
| IP30. |
| Weight | 1.75kg without batteries. |
C-Tec
