Proprietary wireless communication technology to transmit commands, alarms, and events.
Key features:
868.0–868.6 MHz
up to 20 mW
Automatic power control to reduce power consumption and noise interference.
GFSK
up to 1,200 m
Between detector and control panel (or range extender) in an open space.
All the data stored and transmitted are protected by block encryption with a dynamic key.
Radio communication uses frequency hopping to prevent interception and jamming.
2 reed switches
The magnet can be installed to the left or right side of the detector.
small and big one come in the set
The small magnet operates at a distance of up to 1 cm from the detector, and the big magnet — up to 2 cm.
The detector ignores vibrations lasting up to 0.15 s.
Wired detector with the normally closed (NC) contact type.
The siren makes a special sound to notify that the opening detectors are triggered when the system is disarmed.
Do not install the detector using both magnets at the same time. The detector recognizes only one magnet on one side of the detector — left or right.
The device is designed for indoor use only.
Notifications on attempts to detach the detector from the surface or remove it from the mounting panel.
to secure the detector on SmartBracket
device authentication
after 36 s
Detection time depends on the Jeweller or Jeweller/Fibra settings.
1 × CR123A
Pre-installed.
Type C
up to 7 years
2.1-3.3 V?
3 V?
0.013 mA
10.5 mA
1,600 mAh
2.5 V?
2.7 V?
2.1 V?
Device is switched off.
300 mAh
Panasonic
103 × 22 × 21 mm
103 × 22 × 21 mm
55 × 11 × 6 mm
37 g
34 g
from -10 °C to +40 °C
up to 75%
IP50, IK04
Superior DoorProtect Jeweller
SmartBracket mounting panel with holding screw
CR123A battery (pre-installed)
Big magnet
Small magnet
Outside-mounted terminal clamp
Installation kit
Quick start guide