Ajax
| Compatibility | |
| Control panels | Hub Plus Jeweller Hub 2 (2G) Jeweller Hub 2 (4G) Jeweller Hub 2 Plus Jeweller Hub Hybrid (2G) Hub Hybrid (4G) Differences between hubs |
| Range extenders | ReX Jeweller ReX 2 Jeweller |
| Communication | |
| Jeweller communication technology | Proprietary wireless communication technology to transmit commands, alarms, and events. Key features:
|
| Frequency bands | 866.0€“866.5 MHz 868.0€“868.6 MHz 868.7€“869.2 MHz 905.0€“926.5 MHz 915.85€“926.5 MHz 921.0€“922.0 MHz |
| Maximum effective radiated power (ERP) | up to 25 mW Automatic power control to reduce power consumption and noise interference. |
| Radio signal modulation | GFSK |
| Radio signal range | up to 1,700 m Between button and hub (or range extender) in an open space. |
| Encrypted communication | All stored and transmitted data are protected by block encryption featuring a dynamic key. |
| Frequency hopping | Radio communication uses frequency hopping to prevent interception and jamming. |
| Key features | |
| Resettable frangible element | activates the button When the central part (frangible element) is pressed, the button depresses inward, triggering an alarm or initiating a scenario. Two yellow stripes appear at the top and bottom, indicating the device's state. |
| Operating modes | fire alarm scenario trigger With appropriate settings, it activates an alarm or controls Ajax automation devices. |
| LED status indication | fire alarm malfunctions The LED indicator on the device enclosure lights up when a fire alarm is triggered or malfunctions are detected. |
| Interconnected fire detectors alarms | by pressing the button By pressing the frangible element, fire detectors in the system trigger the built-in sirens. |
| Critical alerts | The system can activate intrusion sirens and send audible alarm notifications to users, even if the sound is muted, the Do Not Disturb mode is on, or headphones are connected. |
| Protection against accidental presses | Lift the transparent lid to access the frangible element. The lid protects against false button presses. |
| Alarm transmission to CMS | can be disabled |
| Special tool (key) | |
| Button reset | after pressing To reset the button, insert the special tool into the corresponding hole |
| Hole in the enclosure | to hang on a ring from a keychain The person responsible for fire safety can carry the special tool on their keychain. |
| Convenient dismantling | The special tool opens the lock to dismantle the device from SmartBracket mounting panel. |
| Recommendations | It is recommended to install the button in easily accessible places at a height of 1.4 m. The device is designed for indoor installation only. |
| Sabotage protection | |
| Tamper alarm | Notifies on attempts to detach the button from the surface or remove it from the mounting panel. |
| Protection against spoofing | device authentication |
| Communication loss detection | after 36 s The detection time depends on the Jeweller or Jeweller/Fibra settings. |
| Power supply | |
| Batteries | 2 x CR123A Pre-installed. With typical use (one press lasting 1 minute per week), the batteries can last up to 7 years. |
| Enclosure | |
| Dimensions | 102 x 104 x 39 mm |
| Weight | 214 g |
| Operating temperature range | from 0 °C to +50 °C |
| Operating humidity | up to 80% |
| Complete set | |
| Complete set | ManualCallPoint (Red) Jeweller SmartBracket mounting panel Special tool (key) 2 x CR123A battery (pre-installed) Installation kit Quick start guide |
